In Provectus Hidraulica we have a large stock of honed tubes (polished interior) for the manufacture of hydraulic cylinders of the highest quality.
Our honed tubes are ideal for any application that requires a tube with a polished surface to the millimeter, specially for the manufacture of high pressure hydraulic cylinders.
We have two measures, millimeter and inches. There’s no need to buy a six or eight meters piece, we sell cut tube. Tell us what you need and we will cut it and send it to the address provided.
HONED TUBES, OVER 300 mm ID
We also offer honed tubes over 300 mm inner diameter and up to a length of 14 meters. For this type of tubes please call us (+34 91 438 86 47) or send us an email to email@example.com and we will give you a budget according to your needs.
For more information contact us now. Immediate response.
If you are located in American continent and looking for a honed tube contact our branch office Bufete Systems SA de CV in Mexico city, either through the website or by calling us directly at (+52) 55 56 51 63 66.
IMPORTANCE OF HONED TUBES
Honed tubes are extremely important in the manufacture of a hydraulic cylinder, this is because the piston working inside should have almost the same measure as the tube except for a few microns, these microns are covered by seals which prevent hydraulic oil flows from one side to the other side. If the tube is not honed, whenever the piston moves across the tube it would get stuck. This would cause a failure in the cylinder avoiding correct functioning.